GT280 - Does it replace your current driver?

Mini driver is a 3 wood replacement, not a regular driver.

I think it comes down to needs and gapping. I play a 9.0 degree TSR4, then I previously played a 13.5 Tsi3 3 wood. Then I go to an 18 GT3 5 wood. Disclaimer I play at 6000 feet. My driver carries 320, 5 wood 275. I only hit my TSi3 3 wood off the tee, and there are a lot of times I need to hit it 300, etc.... if i needed an off the deck shot, I would use the 5 wood, only rarely would i use the 3. I just wasn't consistent with it enough. I needed something to split the gapping, as a lot of the time the driver is too much. After 5 rounds with the GT280, I love it. I mean I love it. I play a baby fade, and it just goes. I never want to see my woods go left. #2 at my home course is 625-640 yards. I've hit 4 shots with it off the deck now, and it's nuts. Straight and off the deck I'm getting it almost 300. I honestly didn't think it would get up in the air, but it's so much easier than my previous 3 wood. Did I mention straight? However, back to your question. With your gapping, no it doesn't seem like you would have a place for it. If you're good with your driver and don't need it to be shorter off the tee, I'd say you likely don't need it. I definitely would NOT replace a driver with it; why give up some yardage if you're good with your GT2???

I'm waiting on my GT280 with Tour AD UB-7X shaft to be delivered. I don't have a driver in the bag right now. So the GT280 will be the longes wood in the bag.

My avg numbers from fitting in Trackman:

Club speed: 108 mph.
Ball Speed: 162 mph.
Carry: 280 yd.
Total: 307 yd.
Spin: 2400 rpm.