KBS C-Taper Shaft options

Hi Ron,

The C Taper R+ can be ordered as an "Off menu" shaft which means we will order them as a courtesy to you even though they are not on our custom shaft options.  What we ask is that you do not make any changes or cancellations once the order has been placed.

Cathi, Titleist Club Concierge replied to Re: KBS C-Taper Shaft options in Club Fitting.

Hi Ron, The C Taper R+ can be ordered as an "Off menu" shaft which means we will order them as a courtesy to you even though they are not on our custom shaft options.  What we ask is that you do not make any changes or cancellations once the order has been placed.

You were sent this email because you opted to receive email notifications when someone responded to this forum thread.

View and reply online or reply to this email.

To unsubscribe from this thread, disable notifications here.

 
 
The information transmitted is intended only for the
person or entity to which it is addressed and may
contain confidential and/or privileged material. Any
review, retransmission, dissemination or other use
of, or taking of any action in reliance upon, this
information by persons or entities other than the
intended recipient is prohibited. If you received this
in error, please delete the material from any
computer.

On the wedge shaft - you can order a standard KBS in the wedge length and it is chrome. 

Are the KBS Tour in a wedge length and the KBS Wedge not different shafts?  I think Ron is asking if the KBS Wedge shaft can be ordered in chrome instead of only black nickel.  It appears on the KBS website that the pitching wedge uses the 9 iron shaft - I am wondering about this as well.  Thanks!

We offer the KBS Wedge in the black nickel finish, but, not the chrome version. 

Hi, 

i am currently using AP2 with S300 sharfts in them. I feel like I am hitting it too high and have been contemplating getting new irons. What do you think about doing 3-6 CB and 7-P MB. I want to move away from the S300 shaft so I did some research on the KBS c taper shafts. Can someone give me some addition feedback on the combination of the irons and shafts? 

Thank you

matt, you should hit an AP2 6 iron with the s300 and one with the c-taper next to each other and look at your launch numbers.  The numbers tell all. Do you think you're spinning the s300s too much? There's only one way to find out! Could always go to the project x side of the world. Hit them all!